Fixed: Can’t Access Netgear Router via its IP

Spread the love

Why can’t I access the Netgear router? Why is 192.168.1.1, 192.168.1.0, 192.168.1.2, or 10.0.0.1 IP not working? Where did I go wrong while setting up my Netgear router or updating its firmware? If these queries are bothering you as well, then you are on the right post.

Here, in this piece of writing, we will provide you step-by-step instructions to troubleshoot 192.168.1.1 router IP not working issue in a fly.

We assure you that by end of this post, you are definitely going to resolve the issue on your own. Keep scrolling down!

Tips to Resolve Can’t Access Netgear Router via its Default IP Issue

Here are the steps that you need to consider in order to get rid of the issue in a jiffy. Keep scrolling down!

Tip 1: Power Cycle Your Netgear Router

Sometimes, a small technical glitch can stop you from accessing the administrative page of your Netgear router using its IP. No need to worry! The best way to fix the issue is to power cycle your Netgear router.

Follow the guidelines highlighted below and learn how to restart or power cycle your Netgear router:

  • First things first, power off your Netgear router, but before that consider disconnecting it from your modem and other devices (if connected).
  • Once done, wait patiently for 10-15 minutes.
  • Then, turn the router back on.

After following the instructions highlighted above, connect your router to modem and try to access the 192.168.1.0 IP again on a PC or laptop. Is the issue fixed? If not, then try the next troubleshooting tip outlined underneath.

Tip 2: Use the Default Web Address

Are you sure that you have used the correct IP address to log in to your Netgear router? If not, then you’ve found another reason leading you to the issue. To get the issue fixed, make sure that there aren’t any typos in the IP address. Because, an incorrect IP address may redirect you to a third-party website.

If the issue continues to persist, then it is advised that you make use of www.routerlogin.net instead of 192.168.1.2 IP to log in to your Netgear device.

Tip 3: Update Your Netgear Router

Have you ever noticed that your Netgear router works slowly because of pending updates? Perhaps, the reason why you can’t access Netgear router using its default IP might be outdated firmware. To fix the issue, update the firmware of your Netgear router timely so that you can access the 192.168.1.1, 192.168.1.0, 192.168.1.2, or 10.0.0.1 IP without any issue.

Oops! Updating Netgear router firmware doesn’t resolve the issue to you either? Don’t sweat over it! The only solution that you are left with is to reset your Netgear router back to factory default settings.

Tip 4: Reset Netgear Router

Here are the instructions that you need to follow in order to reset your router back to its factory default settings. Scroll down a little!

  • Make sure that your Netgear router is plugged properly into a working wall outlet.
  • Also, ensure that all the LEDs on the device are stable.
  • Then, locate the reset hole on your Netgear router.
  • Once you’ve located the Netgear router reset hole, take a pin or a paper clip and press it carefully.
  • Hold and release the reset hole.
  • Within a couple of seconds, your router will reset.

In a Nutshell

Once you are done resetting your Netgear router, try to access it using 10.0.0.1 default IP. Hopefully, this time you are able to access your Netgear router using its default IP. On the off chance if the same issue is still spinning your head, do not hesitate to drop us a line into the comments section

Leave a Reply

Your email address will not be published. Required fields are marked *